Answer / nissar

THANK YOU.,
MEENU PRIYA

Answer / minu priya

It is defined as
the sampling frequency should be greater than or equal
to twice the sampling frequency then we can generate
the original signal if the condition does not
satisfy we get the signal in the distorted manner
it is given as ( fs >/ 2 fs)

what is sdh?

11 Answers   Bhel,

---

What is the difference between silicon controlled switch (scs) and gate turn-off switch (gto)?

0 Answers  

---

Explain the operation of 1φ ac voltage controller with rl load?

0 Answers  

---

what is the practical diffference between antenna gain and efficiency?

1 Answers  

---

Write down the expression for the average output voltage for step down and step up chopper?

0 Answers  

---

---

In ics the substrate is not employed as collector. Explain why?

0 Answers  

---

Draw the interface diagram of two microcontrollers?

1 Answers   L&T,

---

What is the need for base values?

0 Answers  

---

Differentiate between microcontroller and microprocessor.

0 Answers  

---

what are X rays? Give there frequency range.

1 Answers  

---

when the generator running trip by earth current even though engine all so shut down the problem showing gcs waring and emergency trip there after starting always gcs locked out what is the problem [this is cummins qsk 23 electronic controle module governer

0 Answers  

---

Explain at what voltage does land line telephone operate?

0 Answers  

---