Answer / kumar

When the engine is place front of the vehicle,
1. When the vehicle move forward, since the air is hitting
directlr over the radiator and engine, the possibility of
engine cooling is high. Hence Powerloss due to over heating
will not arrise.
2. The possibility of fresh intake air without much dust
particles is high. If we place the engine at rear only air
with dust and pollutants will be sucked for intake hence
requires much more filteration and reduce the overall
efficiency.

Answer / g.s.k

front engine volvo bus (its easy to pull than to push as
vertical force vector adds to weight in pushing but in
pulling it is opposite to weight vector)

Answer / bms

A rear engine bus is more efficient,because:
1.more power to weight ratio
2. optimum utilisation of space for seating, uniform and
wide open saloon for passengers,luggage boot,packaging of
driveline components etc.
3. The bus driver has more life to take care of other's..

Answer / ashok leyland

Front engine because rear engine will stumble if situated in steep slopes. Front engines are efficient because of cooling.

Answer / sebhel

Rear engine is more efficient! Because it is easier to get even axle loading plus axle spacing and overall unladen vehicle weight will be less!

Answer / vishnu

the rear engine will be better because in front engine we
put power in rear wheel by propolar shaft and some power
loss is done which will not happen in rear wheel drive, and
if the vehicle gone in any mud or somewhere,and vehicle get
stuck the front wheel affect the first.

Answer / sai kiran

it is safer to hav front wheel engine so that the bus is
steady on hilly roads where slopes are steep. there are
more chances of bus falling backward if it is a rear wheel
engine is in use when bus moving uo hill.

what is cyclon vibration effect in turbine

1 Answers   NTPC,

what is difference between en8 and en24.if the usseage of motor shaft en8 what problems faceing?and what are the advantage of en24?

5 Answers  

what are the main challenges with solar energy system?

1 Answers  

how much clearance is kept in love-jaw coupling between two loves?

1 Answers  

HOW I SHOULD CALCULATE HEAT LOUD

1 Answers  

In Rankine Cycle we use the concept of Tm(mean temperature of heat addition).In actual cycle the efficiency comes as n=1-T2/T1 Taking Tm into consideration it comes as n=1-T2/Tm as T1>Tm so the efficiency for both case will not same for a same cycle. Can anybody explain how it is possible? Advance appreciation for your effort.Thanks

1 Answers   Sail,

how did you go into the mechanical engineering

7 Answers  

What is the law of thermodynamics?

1 Answers  

How do you reset the circuit breaker?

1 Answers   RRB,

how could you diffrentiate between mild steel and stainless steel by using single object. both appears same.

4 Answers   L&T,

how piston moves from bdc to tdc during compression stroke. which force acted to compress the fuel at pressure....

2 Answers  

How a main gate (steel) get support from top whlie slides on the rail fixed on the bottom surface??

1 Answers