What would be the effect of surface roughness on the gas flow
through convergent-divergent nozzle?
Answer / mbm
surface roughness is less or very minimum it should neglected
|Is This Answer Correct ?||0 Yes||1 No|
Question for mech.engineer in dmrc
Explain the difference between “stress and strain”?
Where do you put the oil in a compressor?
what roal of balancing disk in boiler high preesure feed pump.
i having 7.5 kva 1 phase genset,coolant water level is low, so i mix the normal water this is correct or not
what is E.S.P
How much pressure on air reservoir?
whats the range of poissons ratio of a stable material??
state the microstructure of annealed and normalized
What are you going to inspect or check when you open the crankcase?
• What do co-workers say about you
WHAT IS THE DIFFERENCE BETWEEN A 500MW AND A 650 MW BOILER ?