can d.c.transformer exist? if yes then what its max. rating?
Answers were Sorted based on User's Feedback
Answer / mak
Nochance for dc transformer...Flux cant be created in DC...
Is This Answer Correct ? | 12 Yes | 4 No |
Answer / hemanth
Practically IMPOSSIBLE..
ONLY CHANGE IN FLUX LINKED can INDUCE EMF in a coil
In case of DC..FLUX REMAINS CONSTANT AND NO EMF IS INDUCED..
NOTE:
There will be a momentary raise in voltage in secondary when
switching ON or OFF because sudden change in flux linkage..
THIS MIGHT DAMAGE THE WINDING...
Source: Theory and performance of electrical machines by
J.B.GUPTA
Is This Answer Correct ? | 5 Yes | 0 No |
Dc transformer does not exists. because the tranformer
function is to tranfer the power from one circuit to another
circuit. but in dc the flux induced is not flctuating its
constant. so this flux will not induce the flux in secondary
(cutting of flux linkage not happening)
Is This Answer Correct ? | 4 Yes | 1 No |
Answer / arpan87
dc transformers doesn't exist normally but pulsating
transformers are used which supplies short pulses of dc
current...
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / gajanan
chopper circuit which uses semi conductor switching devices
used as step down or step up xmer for dc voltage
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / mahavir jagdev
You can have a DC transformer. But you will need a SCR to create a switched mode power supply to geat the fluctuating voltage, but it will be spkied surges at the other side which when smoothened out using capacitors will result into Dc on the secondary side too .... not a very economical idea as there will be too many losses.
Is This Answer Correct ? | 0 Yes | 2 No |
What is C curve and D curve of MCB?
what is rated speed?
IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace.
I want to know the currect formula for industrial lighting lux caluculation & light fittings selection
how can we detect that which is receiving side and which is sendind end of a trnasmmison line by just seiing it?i.e its which end is coming from genertaing and distribution side?
how you connect the induction motor first in star and then delta in star-delta starter
How will earthing is making for Aeroplane?
any one can explain what is the size of pvc,armoured, various sizes of powr cable dia?
How many no of flip-flops are required to get 16 bit counter
is it possible to run the any motor when winding grounded? how?
What will be MF for below rating ? Main CT PT value is 11kva/110 and 20/5 amp Meter display is 1kva/110v and -/5 amp What will be MF ? Multiplycity factor of energy meter
what will be fault level of 11 KV , 2000 A ELECTRICAL SYSTEM?