Answer / kalidass

This effect is in transmision line. Due to inductence of
the solid cable the all currents will go in outer side of
the cable (skin). To prevent this problem the transmission
cable should be multistrand.

Answer / anand

In dc the current density is uniform all over the cable.....
but in ac the indutive relutance in the ineer part is
grater than the outer one,,,
because the inner part is link by outer and inner flux...
so current pass thrugh the surfce or skin....

Answer / richa

in dc transmission distribution is unniform but in ac due
to inductive relutance it is greater in inner part n less
in outer part

Answer / sunil guru

skin effect is unequal distribution of current at the surface
of conductor rather than bulk... it causes the heating of
conductor..

What are the reasons for AVR failure in LT DGsets ?

2 Answers  

---

Hoe do calculate the Cable size for Amps rating ?

0 Answers  

---

WAHAT IS ELECTRICITY

5 Answers   Vijai Electricals,

---

I have 10 amp MCB for my air conditioner of 1.5 ton capacity. When I connect the ac direct it is started running but when connected through stabliser the Mcb Get trip and air conditioner couldn't start.please confirm whether Mcb is required to be upgraded to 20 amp. There is no fault in ac and the stabliser. Please advice the reason of tripping the mcb when connected through the stabliser.

1 Answers  

---

what happens when the phase and earth wires comes in contact? and why

2 Answers  

---

what is the differences between single phase ind. motor and three phase ind.motor?

3 Answers  

---

Can u explain : how capacitor act when the supply is given is a.c and d.c. I know that when d.c supply is given then the capacitor charges and becomes open circuited. But please say about when a.c is given. I have seen that when a.c supply is given ,it charges and discharges, But when we plug in capacitor to our daily supply and take it out ,then we join those wires spark will appear,which seems charge is present ,but when a.c is given it should charge and discharge

3 Answers  

---

why 3 phase is preferred than 1 phase?

4 Answers   Infosys,

---

HOW TO REDUCE POWER PLANT AUXILIARY POWER CONSUMPTION?

0 Answers   TATA,

---

can we install HT panel & LT panel side by side or how much clearance is required ?

0 Answers  

---

what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering

0 Answers  

---

any earth foult trip the relay but in welding time not trip by earth foult

0 Answers   Power Grid, Siemens,

---