Is it good to short Neutral and Ground in the PLC or DCS
main Power supply. Pls give YES or NO with reasons...?
Simarpreet
No Answer is Posted For this Question
Be the First to Post Answer
How do you find HT and LT sides of a distribution transformer only by looking at it from outside?
for a slip ring induction motor if the stator is short circuited and rotor is given supply? how does the rotor rotate?
1 Answers TNEB Tamil Nadu Electricity Board,
Transmission line design. Say, I have a 1MVA generator and 2 transformers that will have the same load. What would be the proper rating of the trasformers? Is it safe to say, that I will simply divide the total rating of the generator?
How to conduct the Magnetic Balance test on Power Transformer?
In response to Mr Bikas. If fault current is 52 kA then what will be the CT specification
which types of tests are required after commissioning of 6.6 kva tranformer?
Why tripping not occur when the transmission lines (11KV & above) breaks? Doesn't we provide earthfault protection for it?
What is the kva?
2 Answers Makino Auto, SAL Steel Power, Sapphire Group,
State nyquist stability criterion.
What is the purpose of stablization resistor in high impedance bus bar protection
could i arrange a faulty and healthey battery bank togather in parallel , if your ans is not then why?
why the neutral line is not giving shock to us if we touch it ?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)