Is it good to short Neutral and Ground in the PLC or DCS
main Power supply. Pls give YES or NO with reasons...?
Simarpreet
- 1 Answers
- 2633 Views
- Bindal Papers, I also Faced
- E-Mail Answers
Answer Posted / Amritansh Mishra
NO, it is NOT good to short neutral and ground in the PLC or DCS main power supply. This could lead to system failure, damage to equipment, and potential safety hazards due to electrical shock or fire. Shorting neutral and ground creates a direct current path, which can interfere with the proper functioning of the control system.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What the main causes of transient interruptions on Over-Head Distribution Lines?
what is thermal resistance of PVC Cable.
could anybody able 2 send me jindal steels previous papers fr electrical steam....pls send 2 my id if possible....sirisha.shaik@gmail.com
kindly send me 11KV MV motor differential protection procedure by primary injection method.
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
How I can Compare 120v/60Hz versus 220v/50Hz ? Please tell me both advantage and disadvantage ......
How much minimum insulation required between 11kv/3.3kv transformer windings?
Draw the circuit of clapp oscillator?
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
hi can anyone pls tell me the eee interview core questions asked in l&t
hi plz send me reliance placement papers..i.e electrical technical papers that have been asked in reliance test.
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
Do you need any help with FEWA Electrical Supervisor exams?
Circuit diagram of tube light without starter using electrical choke
why and how voltage sharing in transformer, during magnetic balance test ?
