A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
VECL,
2006What is meant by load angle of an alternator? Upon what factors does the load angle depend?
VECL,
2556How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
VECL,
1553We have 11kV/110V three phase indoor potential transformer in 66/11kV Sub-station, where the failure of PT is frequently happening and the rating of the PT is 0.2 class accuracy, with primary star and seconday (two cores) star connected. Some experts has suggested to not to connect the PT Primary neutral to the ground because when transformer neutal NCT connection is loose; the faulty current will flow through the PT primary neutral, resulting into failure of PT. My question is: Is it necessary to remove the primary neutral connection of the PT from ground? if not, what would be the reason for failure of PT. Please guide me.
2 2793How much ph is maintained of water electrolyte which is used in LRS for 1200 kw slipring induction motor ?
1242Post New Electrical Engineering Questions
what is the maintaining Cf in UPS.
How you calculating the 30 Hp 3 phase AC motor of power what size of cable is used for this motor?
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
can u tell me the promotion from oiller to enginer
Is it true online ups having bypass mode if it is true then why we called ups because it is interrupting power when goes in bypass mode
how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?
placing earthing pit in pathway is correct or wrong??. placing earthing wireGI1/18 inside walls is correct or wrong?. explain!!!
66kv under ground cable how to layaing in ground any special case two ckt r runing
what is efficient motors and how it is different from normal induction motors
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
how to find the resistance and gap volatage of the diode??
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
what is the circulate the diesel in DG in side pls tell parts name and picture with circulate the diesel
Difference between low impedance and high impedance Restricted Earth Fault
What kinds of decision are made about CT from it's Knee point(voltage & current)?