i am getting to neutral earth voltage zero ,is this a perfect earthing ?
Answers were Sorted based on User's Feedback
Answer / sandhya
S it is crct ..as the earth potential should be zero always
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / dipesh
yes.it is good.but for sure check earthing resistance.it should be less then 0.5 ohm.
| Is This Answer Correct ? | 0 Yes | 0 No |
why we use to always generate power below 16kv.why not at higher voltage?
what is the difference between surge arrestor and lightning arrestor ?
Why we are using Ohm's law? where it is applicable? explain.
10 Answers Pyramid Saimira, TCS,
Why RCD trips on connecting to one Socket but not trips one other circuit on same RCD.
why we use single core 630mm2 cable for transformer secondary side
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
Where servomechanism is used?
How many speed of dg start motor for engine starting time
what are types of ups?
Why should we use jelly filled armoured cables in underground Communication system? What is the use of the Jelly? If we go for unarmoured, then what happens?
I am inpecting a 10kVA UPS what tests should i do and should i observe?
What is power factof?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)