why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
2060What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
3109why do mostly prefer to generate and distribute electricity in 3 phase..not in 4 phase or 5 phase.??
5 7923When we need start the motor by method of star delta which size (KW or HP)motor should must be operate in Star Delta Method,
3 4038Post New Electrical Engineering Questions
Why the power factor improvement is so important in industrial loads
what is the main parts of transformer? how it is functioning? pls giv the ans briefly.
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
define as synchronous generator
explain wiring system
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
Explain the terms real power, apparent power and reactive power for ac circuits and also the units used.
Who many reason of ignition fail ?
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
What is the function of electron gun assembly used in crt?