how to make neutral to ground voltage less than 5v? my house is under the high voltage transmission line so,proper grounding using rod salt n coal doesnt help me..so wat i do as i cant operate my computer ..this high voltage cause great problem to the motherboard i already two times replaced it.in my house voltage is coming near to 25 v between ground and neutral.plz kindly post ur answer to my email id manish77777@gmail.com ..
3 12839What are the necessary solutions needed to be carried out on a malfunctioned earthing mechanism of a VACUUM CIRCUIT BREAKER.(TAMCO)
1964what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
L&T,
2158Post New Electrical Engineering Questions
How to know Resistance and Reactance value of main and aux winding of single phase capacitor start capacitor run induction motor to find capacitor value?
What is the difference between multimeter
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
Why syn. Generators are used for the production of electricity?
any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.
mention hazard experienced during installation
Write the current equation in series RLC circuits.
I want to know Electrical Circuit?
What is contract demand in solar system?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
what is meant by vector group of a transformer? How can it be derived?
how is working bearing heater?
Please give me a erda placement paper
Draw the circuit of clapp oscillator?