Is there a necessity for providing expansion joints in long RCC structure(say a wall of a water retaining structure)- say approximately 50 metres in length and about 4 metres high? What will be the limitations?2 5866
what is a steel formula13 31264
how to calculate quantities of sand , cement & aggregate in 1m3 - M20 , 1m2 of 6mm/12mm/20mm plaster , 1m3 20cm/ 1m2 of 10cm brick wall, paint quantity for 1m2 snowcem and lime painting?3 63055
what is difference between open and well foundation ?2 20296
What is the Density of Steel & Conccrete7 10967
What is the consumption of Brick in one meter cube both 6inch & 4inch thick4 5959
what is the bearing capacity of hard rock7 11638
what"s the formula to find the cement,sand,aggreegate(45mm) requirement for PCC?5 43129
how do we calculate wastage of steel in the site,what r the items to taken into account for wastage calculation?4 22455
what is piers?4 3804
WHAT IS THE SPLICE LENGTH WHEN WELD IN REINFORCEMENT STEEL8 7611
Wat is the optimum value of tensile strength of concrete after 28 days??1 5023
1. For 10sq.m area(47 kg bitumen contain) of 45 mm thick bitumen mix layer..how much bitumen is required for 1600 sq.m and how much aggregate need for that ?? 2. And much tonnage of bitumen mix required for 10 sq.m area of 45 mm thick. Please give answer...
what are the challenges of being a team leader and a supervisor?
How to calculate Volume of Wet cement concrete for a specific grade?
DO YOU HAVE REFERENCE LIST?
what is Short bored pile foundation.
what is concrete canvas?
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
For the symmetrical continuous beam shown in figure, Prestressed with a force P = 1500 KN along parabolic curve as shown, compute the extreme fiber stresses over the central support for the uniformly distributed load of 24 kn/m. Use load balancing method.
cud any one send me tech quest paper(civil engg) at firstname.lastname@example.org
How reactor of SBR installed , is it be over ground, fully under ground or semi sunk ?
How many % we consider for lap for reinforcement for estimates
How we can calculate the cement, sand,bricks , water , quintity in 1:6 Ratio 1 cubic metre b/w and 1:4 Ratio in 1 Squre metre b/w????
How can I make justification between using concrete grade c35 compare c37?
how to caliculate required amount of cement and sand required for 1cu.m.
how can can column be corrected when the design is not safe ? is the increasing the clearcover a solution?