Civil Engineering Interview Questions

Questions
Answers
Views
Company
eMail

In concrete mix, water is required . we tried in case of water we are used milk. what hapened

What are the advantages and disadvantages of Solid blocks over clay bricks in civil constructions ?

If in school there are 1800 students and 80 staff how much water can be used by them per day?

1.WHERE THE SLAG CEMENT IS MAINLY USED. 2.FOR GOOD CONCRETE MIX OF M20 GRADE , CAN IT BE USED? 3. I WE USE FOR BRICKWORLiK AND PLASTERING ANY DISADVANTAGES?E

draw the sfd and bmd of catilever beam subjected to point load and udl. plot graphically the difference in deflection pattern of simply supported and cantilever beam subjected to point load.

what are the compressive strength requirements(in 7 days & 28 days) of cement sand mix used for plastering purpose (Cement:sand-1:6)? Kindly give the IS Code reference also.

L&T,

Post New Civil Engineering Questions

Un-Answered Questions { Civil Engineering }

what is the difference b/w full length and cutting length?

Civil engineering related

i need the syllabus for the direcr recruitement of executive engineers in andhrapradesh

How can I make justification between using concrete grade c35 compare c37?

What do you mean by bond? What are the different types of bonds?

what is the 0 value in quantity surveying

A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.

how to calculate detail quantity of bricks and mortar for 500 cu.ft masonry work. consider wall thickness 9 inches

Can you pl explain the procedure steps of singly and doubly reinforced beams in limit state method

Dear Sir I Mahesh C. Bhamre have already given a Exam for Superintendent Officer / Public relation Officer Exam Dharmday Aaukta held at Nashik on Date 29/08/2010. My seat no was 5040247. and my cell no is 9822677994. and my mail Id is - mahesh.bhamre@rediffmail.com So can you pl send me details of result of respective exams. Thanking you in Anticipation.

How many % we consider for lap for reinforcement for estimates

what is cement wastage percentage in NHAI ROAD WORKS

if a pipe those configuration (ASTM c 76 class b 450mm dia 2500mm length) fixing for water course those lining of water is 7000 running meter. my question is that if 8 joints of pipe ls leakage and we have not permission to stop the water so which treatment we apply on joint in that in condition.

I measured pcc work as 15.34 m cube , the ratio is 1:5:10 ,want to know the cement, sand and metal used for pcc measured as 15.34 m cube at this ratio.

what is zone a n zone b?why the spacing of ring in zone a less.n zone b high?