Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) Calculate the maximum allowable speed on a horizontal curve of radius 350m if the maximum allowable values of the lateral coefficient of friction are 0.14 and the rate of superelevation is 0.08.
2512substance is flowing in a pipe of 200 mm inside cylinder diameter ot an average velocity of 3m/sec. At a given section of the pipe line the pressure is 1.5 MN/m² absolute. what is the flow work of 0.5 cubic meter, expressed in joules passing through section? (a)1J, (b)75000J, (c)90000J, (d)25000J
1 3984how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
1045
what are the different methods for the starting of a synchronous motor.
please give me solution to rectify the emi(electromagnetic interference)
In Telecom, While call set up what are the Masseges will flow from all network element to each other.
how will we calculate the copper wire load..
if dia of inner circle is 42 m and depth is 1.5 m and width is 1 m ,then whait is the quantity of steel?
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
At high frequencies, what is the type of noise that becomes of great importance. Explain the use of a delayed ECG?
the magnitude of the buoyant force can be determine by newtons law of viscosity archimidies principal principles of momemnt none
For a washout valve why are two gate valves required in normal practice?
Explain what is an fpga?
what is upper impedance and lower impedance of a distance relay
What is the difference between operator overloading and function overloading in C when compared with C++?
What is critical path method (c.p.m)?
What measures do you take to ensure product quality and consistency throughout the manufacturing process?
How can you measure liquid level with electronic method?