Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) What is a bcd? What are its advantages and disadvantages? Why is an excess-3 code is called an unweighted code?
1056In connections of mcb, is it necessary that the incoming side supply should be connected at top side of mcb. Whether this has any effect in tripping of mcb in case of fault?
1024
what happen if the parallel generator phase angle shift by 1 degree in manual mode
please give me all the Alarm .Trip ,Safety Relays & Conditions of Chiller mail me on ashokbabunhce@gmail.com
how can power amp inc the power without inc the voltage or current values?
The server is already having the list of IP addresses of all its authorized clients & if any client is requesting the server to do a task, it is sending its IP address(encapsulated in the packet) to the server.The server can easily match that IP address with that on its list and check if it's authorized client or not, then why we need inverse domain...........
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
I would like to get the formula How can i calculate the productivity of a mason in terms of brick laying and plaster. i have 6000 Sqmt of interlock laying work i want to calculate - how many masons required to do the job - in how many days can it be done - what will be the production rate in 8 hours shift/ per mason if i can get some excell sheet , it will really help me in my calculations
how a three wire proximity can be used in place of two wire proximity?
What is monotonic dac?
What are the functions performed by rudder?
A channel has a bit rate of 4kbps and a propagation delay of 20msec. For what range of frame sizes does stop-and-wait give an efficiency of at least 50%
What is the purpose of turning gear
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
sir i need section engineer test papers
List the different devices and components of main switchboard.
What is the advantage and disadvantages have the small amount of super heat for the refrigerant vapors entering the compressors suctions?