Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) How to calculate the flow rate in Vortex flow meter?What is K factor?Can you give me an example calculation to understand the same as better?
1 4571Is your basic salary of $...... , good for you if employed?In case of any eventuailt,who is your next of kin?
1669
Explain about safety integrated level protection? . How it was differ from other protections ?
I need some information on EOT CRANES AVAILABILITY calculation and criteria.
What parameters to be reported when we send lubricating oil for shore analysis?
If 320 grade Gear oil is used in a reduction gear box,what can be themaximum operating temperature of the gear box?
What is normal radiation field out side the reactor building?
What are some factors to consider when trying choosing between a dry screw compressor and an oil-flooded screw compressor?
Difference between pre-tensioning and post-tensioning.
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
Howmuch bend to be provide for 200/600 BEEM
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
Draw and explain a mod-10 counter.
what will happen if frequency is below 50 hz?
hello i have a problem !!!! i am studying gait analysis"human walking; and i had only single camera"sony 25 frames/s" and 2 separated force plates, and there is no synchronization between the camera and the force plates!. i wrote a matlab program to calculate joints moment(sagital) using inverse dynamics methode. and there is a problem with the output data!! can you help me.
what is laser diodes?
plz tell me which books r important for gate exam (CSE)