Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) 1. For 10sq.m area(47 kg bitumen contain) of 45 mm thick bitumen mix layer..how much bitumen is required for 1600 sq.m and how much aggregate need for that ?? 2. And much tonnage of bitumen mix required for 10 sq.m area of 45 mm thick. Please give answer...
2051if a 2 ohm resistor,2 ohm capacitor and a 2 ohm inductor is connected parallely to 12v source.Then what is the value of current in each branch.Is current flows in each branch at the same time?If not so then provide the proper sequence
1 3099Please Clear My doubt . We Can Design the size of the beam by manually by the Length of the beam...What is the technique adopted
1730According to ohms law voltage proportional to current, then why should current rating is low with high voltage rating in transformer?
KEC,
5 7880
design a 3 bit synchronous and asynchronous counter using T- flipflop
Write the current equation in series RLC circuits.
Explain why the input impedance of op-amp is so high?
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
How do you calculate load bearing capacity of a waffle slab?
full process of gas turbin?
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
we have a bore well 275 depth & water is deliver at distance of 1000 feet from the borewell here iam not include the distance of depth and the deliver water horizontally at our reserviour tank on ground level
what is your experience with computer-aided design software.
Define current ucs?
Why is buprenorphine less addictive than other opioids?
why dont call datareader is backward
How do you change a dimension value in solidsworks?
Define What are the uses of Groynes?
what is the technology used in sap?