What is the differences of Level swich( LS ) and Level Transmitter(LT)

Question Posted / mathew

2 Answers
7348 Views
Hi Spectra, Sipra, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is the differences of Level swich( LS ) and Level Transmitter(LT)..

Answer / er. anish raj

Level Switch performs only switching mechanism. ie. when its electronic circuitry senses the present level is the desired one then its relay coil will operate & the NO contact will turn into NC and vice versa.
Whereas the Level Transmitter will visualize the signal, perform signal conditioning ( amplification) and then transmit the current signal to the controller in the form of 4-20 mA.

Thanks.

Is This Answer Correct ?

14 Yes

0 No

What is the differences of Level swich( LS ) and Level Transmitter(LT)..

Answer / manan2347

Lavel switch is Digital input where it gives only two single either ON (1) or OFF (0).

where level transmitter gives analog output means value of the output will vary with respect to time.
generally its between 4 to 20mA.

Is This Answer Correct ?

13 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.

0 Answers Essar,

why is honed type flow orifice plate? what purpose it used? how to select this?

4 Answers

what is the principale of vortex flow meter.

7 Answers Ambuja, India Glycols,

What is the difference between HMI,SCADA and MMI,not abbrevation?

7 Answers HCL,

Witch type cable use for rtd ,why?

2 Answers Sugar Factory,

What is the working principal of Mass flow transmitter?

1 Answers

Q- voltage source of 12v is driving the circuit.if circut draw the current of 0.5A them source voltage will became 11.8v.what is the power dilevered by source when circuit draw 5A current ?

4 Answers Ecil,

I am going to attend a recruitment drive by Schneider in 2 weeks. They have a technical test in the beginning. I would like to know what are the areas i should concentrate on while preparing for the test. My major is Electronics and Instrumentation.

1 Answers

How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?

0 Answers

A differential pressure transmitter is configured to measure the height of an open tank : height 10m and dia 5m. Suppose this same transmitter is shifted to another open tank : height 10m and dia 4m. What will be the %error in measurement? how?

3 Answers McCoy Engineering,

Difine flashing , Cavitaion & Noise? how to minimize these effects

3 Answers L&T,

Why we use the remote seal transmitters

1 Answers Oil and Gas Jobs,

For more Instrumentation Interview Questions Click Here