Which standard is used for calibration of Control Valves ?
Answers were Sorted based on User's Feedback
Answer / earnest
0.2 bar - 0%, 0.4 - 25 %, 0.6 - 50 %, 0.8 - 75% and 1bar -
100%
Is This Answer Correct ? | 18 Yes | 0 No |
I have seen the Temperature element (T/C & RTD) installed in process line on 45 degree position, Why? What it mean? How many types of tapping position for temperature elements?
what is the working principle of dis-placer type level transmitter
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
if tx. dp increase or decrese what happend in the reading
how to calibrate temprature switch and flow switch ?
How works weighfeeders in cement industry? what is the working principle?
What is mean by Ethernet, Device net and Control net? For what application we are using these?
tell me the temp range of rtd?
Ega interview going on for power plant. Which type of question will asked. For questions
If Solenoidal valve works in manual mode but not in Auto mode. What should be the problem?
8 Answers Bharathi Cement, Titanium,
d/p flow transmitter LP side give to pressure.what you geting out put ? how you get(ma)?
what is compensation in engineering and what is temperature compensation?