Which standard is used for calibration of Control Valves ?
- 2 Answers
- 6878 Views
- I also Faced
- E-Mail Answers
Answer Posted / earnest
0.2 to 1 bar or 3 to 15 psi
| Is This Answer Correct ? | 26 Yes | 2 No |
Post New Answer View All Answers
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
Square root calculation for dp flow transmitter?
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
How process line mpm calculation is done?
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
State some of balance principle’ advantages?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
How to calibrate Field bus transmitter? procedure ?
