What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?

0 Answers   KNPC,

---

i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure

0 Answers  

---

Can anybody tell me application of PLC,DCS,SCADA.

3 Answers   Reliance,

---

How to isolate a DPT from line in the condition that process must not be disturbed,and process is also critical and no bypass is available.?

4 Answers   Descon,

---

we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.

0 Answers  

---

What is the purpose of LO Overhead tank in turbines.

0 Answers   ADMA OPCO,

---

What is surge in compressors? How to detect and control it?

3 Answers   Kharafi National,

---

what are the possible reasons if a control valve fails to open/close?

1 Answers   DEWA,

---

What are the types of control valves available

0 Answers   CCIE,

---

how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?

0 Answers  

---

For an Instrumentation Engineer, is there any effect on Instruments of safety zones like zone0, zone1, zone2. As an instrumentation Engineer, what we have to consider or remember while working in these areas.( zones 0,1,2).

1 Answers  

---

What is Square Root Extractor for?

9 Answers   Sabic,

---