Answer / mprajaneb

Scan time depends on PLCs. In the timing diagram of PLC
execution we have three different times.
1. Input scan time
2. Execution time
3. Output scan time.
Input scan time the PLC receiving the data status from the
input peripherals.
Execution time is the time required to execute the program
or for scanning the rungs in PLC program.
Output scan time is the time required to send the results
to the output devices as per the execution of the program
rungs.

Answer / balakrishnan

Scan time vary based on PLC models. Scan time means scannin
of ladder rungs in PLC program ( ONE time) for all the
rungs.

Answer / sanjana singh

scan time in plc is 10ms.
it depends on the length of programme.

WHAT IS SEMICONDUCTOR? EXPLAIN DETAIL. FOR EXAMPLE TAKE A PENCIL.THE LEAD IS MADE UP OF GRAPHITE IT IS A CONDUCTOR.THE OUTER COVER IS MADE UP OF WOOD IT IS INSULATOR.PENCIL IS A SEMICODUCTOR MATERIAL.

5 Answers  

---

what happens if the phase sequence of parrlel connected sys will changed & phase displacement

1 Answers  

---

Iin ESP why positive is grounded ? why not negative ?

0 Answers  

---

what will happen if the field and armature both are made to rotate in a synchronous machine ?

4 Answers  

---

how much excitation voltage required to generate 1mw power?

0 Answers   Saudi Oger,

---

what is inrush curent.

5 Answers   BARC,

---

IF we have 500kva transformer 11.0/0.415V, 50Hz. How to calculate the current on HT & LT side, how can we consider for its breaker (HT & LT both)? You are requested to solve the question herewith.

3 Answers   Bhutan Power Corporation,

---

what is reactive power is it good or bad for a system

5 Answers  

---

How to run 1ph motor(230 VOLTS its full load amps is 4.5 ampa))with 480 volts main(we didn hav neutral)Thn we go for step down transformer.Our load 10 amps,so we conisder this amps in primary are secondary side

1 Answers  

---

what is the difference between current rating and breaking current of an MCCB? and for a known load how to calculate the current rating of a MCCB?

1 Answers   HPL,

---

Refernce currents are to be generated using refernce cueernts how can this be done??

0 Answers  

---

how can we test the polarity of a 3-phase transformer?

2 Answers  

---