How are harmonics produced in AC machines?
Answers were Sorted based on User's Feedback
Answer / anamika
IT IS DUE TO NONSINUSOIDAL DISTRIBUTION OF MAGNETIC FLUX
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / raju
Harmonics are any “Non-Linear†Current or Voltage in an electrical distribution system. They are commonly produced by devices that rectifies AC Voltage into a DC Voltage like VFD, Lighting, and Computer.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / elangkumanan
transformer saturation problem
ht capacitor
lt capacitor
synchronics machines.
Is This Answer Correct ? | 4 Yes | 21 No |
WHY DISEL GENRATOR SET SHUT DOWN IN OVER LOAD CONDITIONS
what is mathed of check the D.C MOTOR 181 KW (ARMATURE AND FIELD) WHAT IS THE MATHED OF CHECK THE THYRISTOR MODULE (HIGH CURRENT)
what is power factor? is it good or bad for a system? what will happen if power factor increase or decrease?
What is the intent of short circuit studies?
why we are useing capciter in EB meter?
What is the need for a controller?
Dear Sirs, I am a technical persons.In one of our Electrical Sub- Station, We have installed three numbers of 1250KVA ,11KV/0.415KV Transformer to feed the Factory load. We have found some abnormality. In one of our Transformers the leakeage current from transformer body to earth through earth continuity wire is almost 86 Amp but in other transformer it is (5-10)Amp. where the load current on three phase and neutral are respectively 1360Amp,1400Amp,1370 Amp & 176Amp. So please any technical person help me about the reasons of this situation and how I can rectify the fault. Moreover,I have measured the earth resistance of the Earth continuity wire which is less than 1 Ohm. Thanks Tapas Barua
A transformer has negative voltage regulation when its load PF is A zero B unity C lagging D leading
what is the difference between ac and dc?which one is more efficient?and what r their advantages
i am using star-delta connections with reverse/forward direction motion of the 75hp induction motor.What should be the ratings of Main,Delta and Star contactors and why?
how to calculate transformer load?
what is diffrent between plc and clc??