Answer / ullas k prabhu

Some times the motor may continue to rotate with lots of
heat dissipation or the motor windings might be suddenly
burnt which mainly depends on the class of insulators
used.... It also depends on the heating and cooling time
constants...

Answer / sri valli

for any m/c since current passes through the armature heat
is devolped due to resistence so it is to be cooled through
ventilation to provide long life to the conductor

Answer / john h

This actually is hard to answer because the heat generated
may not actually be surpassing the thermal capacity of the
motor to disapate heat even unvented. If the motor is
producing excess heat which surpasses the operating
specifications of the motor design then it will reduce its
lifespan and fail. It also could be producing excess or
reduced windage (air resistance) reducing the effectiveness
of the motor.

Answer / vimal dixit

Surely it will burn out. After poor ventilation burning time
depends upon load on motor, surround atmosphere of motor and
motor life.

Answer / mrt

for running motor cooling air fan at non drive end side is
important because the motor winding temperature is
increases. if cooling fails the motor temperature increses
and sometime depends on the load the motor will burnt out.

Rated moter voltage and frequency is 380volt 60 hz but moter is running at 380votac 50hz is this harmful for moter winding

1 Answers   Infosys,

What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?

0 Answers  

respected sir, sir recentely i have applied for chennai and tiruvananthapur section enggineer and juniour engg in electrical dept. but still i donot get how i have to syart my preparation and also t the same time i donot know exactly what they r going to give in the examinations i mean which sections they r going to give i donot know exactly, can u prefer whichh books i have to follow and model papers or both boards

1 Answers  

we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.

0 Answers  

Differnce between negative Pahse SequenceFunction and unbalance Function?

0 Answers   Atsco, LMW Lakshmi Machine Works Limited,

What is meant by Floating Neutral? how to prent

7 Answers  

what is mutual induction principle?

2 Answers  

brief notes on ammeters

0 Answers  

explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?

0 Answers  

any calculation method for decide cable size for current?

1 Answers  

detailed procedure how we calculate cost for pcc m10 and rcc m20 including centering and labour excluding steel/ iron

0 Answers  

1600 KVA ka transformer hi aghar lt side par 800A aur voltage 420 ho to HT side ki cable ki rating keya ho gi?

0 Answers