respected sir,
sir recentely i have applied for chennai and
tiruvananthapur section enggineer and juniour engg in
electrical dept.
but still i donot get how i have to syart my preparation
and also t the same time i donot know exactly what they r
going to give in the examinations i mean which sections
they r going to give i donot know exactly, can u prefer
whichh books i have to follow and model papers or both
boards
HOw can we calculate power factor at HT side.
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
How to calculate Number of Earthing Pits....???
what is the importance of Partial Dischage test for Electrical Equipments
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
0 Answers TNEB Tamil Nadu Electricity Board, Vestas,
In Star type and Delta type Motors, If one phase will miss/Break then which phase winding will burn and why?
Please tell me if you are electrical engineer,and you are appointed for the maintainance of Electrical Power plant,then which parts of the plant deal with you.Also tell how these parts/components work.
What is the main feature of v/f control?
which transfofrmer oil break down voltage strength get will be more if oil sample taken from bottom of tank or oil sample taken from top of the transfomer tank.
Why the Motor takes High Current in Starting time?
1. Synchronization is not required A. Thermal B.Hydel C.Wind D.Nuclear
2 Answers APGenco, Birla Power,