Answer / va

As instruments need clean air supply which should be mixed
with moisture and oil from compressor. For that purpose the
air dyer is used which heat,cool and filter compressed air,
which remove the all above. So it specially used for
instrumentation purpose. So it is called INSTRUMENTATION
AIR COMRESSOR

Answer / abhishek vyas

Basically in organization there diffrent pressure required
say 6kg/cm. sq. to 16 kg/cm.sq. for diffrent purpose so
utility area has configure their compressore as per
pressure required ,6kg/cm.sq pressure is the basic
requirement for control valve,actuator etc so that
compressore is called instrument air compressore which is
producig 7.0 kg./cm. sq. taking the fact in considaration
of Air savig and power saving.

where cascade loop use ?

0 Answers   KNPC, KOC,

---

what is PID n give me brief info. about P&I&D.

2 Answers  

---

What is open loop and close loop?

4 Answers   L&T, Pearl Distillery,

---

what effects a surging can produce in the compressor

0 Answers   Nemat,

---

What is instrumentation control?

0 Answers  

---

Shall we get the reading on level transmitter only by termination,without commissioning?

1 Answers  

---

Why 24VDC power Supply is used as standard for all loop powered transmitters?

8 Answers   Lupin,

---

what is difference between modbus & fieldbus

1 Answers   ABB,

---

can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.

0 Answers  

---

what is dry leg and wet leg in transmeter calibration?

3 Answers  

---

SIR MAY I KNOW IF RADAR TYPE LEVEL TRANSMITTER SHOWING IN THE FIELD 0 % LEVEL AND IN DCS SHOWING 100% THEN WHAT IS THE CAUSE I CLEAN THE CHAMBER & TAKEN ONLINE BUT ONLY ONCE ITS BECOME ZERO IN DCS BUT AGAIN 100% SHOWING IN DCS,THEN I REMOVE THE POWER SUPLLY AND CONNECT IT AGAIN .IS IT OK BUT STILL IN THE DCS ITS 100% AND ON THE DISPLAY ITS INITILAZIATION PLEASE HELP ME READRING THIS?

4 Answers  

---

how to calibrate TT transmitter

3 Answers  

---