which type of material is used to transformer laminated
core?
Answers were Sorted based on User's Feedback
Answer / karthik raman.b
silicon steel for reducing hysteresis loss
Is This Answer Correct ? | 13 Yes | 0 No |
Answer / gunasekaran
varnish for core wdg synthetic resin bond paper
Is This Answer Correct ? | 5 Yes | 2 No |
Answer / dinesh
HI or HI-B grade Cold Rolled Grain Oriented (CRGO) silicon steel....
The grade depends upon the thickness of the lamination sheets.
Hi-grade- M4, M5, M3
HI-B GRADE- M0H, ZDKH(LASER SCRIBD)....
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / elangkumanan
type of material is transformer laminated core silicon
seal
Is This Answer Correct ? | 6 Yes | 4 No |
Answer / muhammad abid ali shah
Ferromegnatic core is most useful for the transformer.
Is This Answer Correct ? | 1 Yes | 1 No |
What is the difference between amorphous core transformer and CRGO core transformer?.
Dear all, is ther any body who can tell me about the setting of ACB(air circuit breaker ). what kind of it,s setting is and how to do it,s setting. also please tell me the setting of VCB(vaccume circuit breaker) . please tell me their setting,s. i will b very thank ful to all of u. Thank,s and Regard,s. Muhammed Ikram.
We in my plant one of the transformer showing neutral to earth voltage is 22V how to solve it
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
What is instrumental error?
what is reluctance?
some ac motor's direction get change dueto ghanging input to the ac drives.(say ryb to rby). but some motor direction remains the same when phase sequence is changed fromdive side. can anybody guide me?
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
if a damaged 500kva transformer with %impedance 2.6 is replaced by two transformers of 250Kva with different % impedance will they be able to catter the load. what will be the ratio of load on the two transformers if the % impedance is in the ratio 1:2
what is the difference between electrical wire and electrical conductor?
which one is dangerous AC Power r DC Power for Electrical Shock ?
When measuring the Insulation resistance of a motor winding (winding to earth) using a megger meter, Applied voltage(1000V) was automatically reduced to 500V. and the measured insulation resistance values are also very low (in Kohm range) Can anyone give me a reason???