Basic philosophy of applying 3P tripping for uptill 132KV
switchyards & for 132KV & above 1P/3P tripping is used.
Answer / chandrasen mourya
Because most of the line used for transmission by EB are of
220 & 400kV . These lines are of lenght greater then 50 kms.
Due to which any arcing fault which is temp can trip the
line & total suhtdown. The 1p/3p trip with single shot or
multi shot AR is provided in 132kv & above.
Is This Answer Correct ? | 0 Yes | 2 No |
railway exam in asst loco pilot old test paper
25 Answers Indian Railways, Loco Pilot, RRB, Southern Railways, TATA, Vimal,
Explain the Term in CT Name Plate – Class: 5P10
For a 500 MVA 400/220/33KV transformer following data given HV power = 500 MVA IV power = 500 MVA LV power = 5 MVA If input power is 500 MVA then how output power is (500+5)MVA. Can anyone help
DRAW THE DIFFERENCE BETWEEN GROUND AND NEUTRAL IN BOTH SINGLE PHASE AND THREE PHASE?
What is the basic difference between the electrical engineering and electronic engineering?
what is the basis for selection of Protection CT class ? How anyone can decide whether to go for 5P10 or 5P20 ?
what is diff b/w electrical & electronics ?
what is the function of switch gear ?
what is the function of choke in a tubelight
when is the Ohms law is applicable?
in 4 pole lap wound dc motor one brush is disconnected then what result in new voltage if its voltage is v volts power is p watts current is i amp
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
0 Answers Reliance, Southco Utility,