Basic philosophy of applying 3P tripping for uptill 132KV
switchyards & for 132KV & above 1P/3P tripping is used.
- 1 Answers
- 3660 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / chandrasen mourya
Because most of the line used for transmission by EB are of
220 & 400kV . These lines are of lenght greater then 50 kms.
Due to which any arcing fault which is temp can trip the
line & total suhtdown. The 1p/3p trip with single shot or
multi shot AR is provided in 132kv & above.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Define phase lag and phase lead?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
high voltage transformer input voltage,current and amps rating..distributed transformer input voltage,current and amps rating...
Define settling time.
WHAT KIND OF LIGHTENING PROTECTION SCHEMS CAN BE ADOPTED FOR THE FLAT ROOF OF BIG DIMENSION.
Define rise time.
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
Define cuttoff frequency?
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
