Answer / praveenkumar s

by using "transuducer" we can convert any electrical signal
into 0-10v and 4-20mA

Answer / dubai

As said by praveen, i would like to add one point to this
answer.

0-10 volt is an analog value which is first converted to
digital value via A/D convertor in PLC analog input module
& then D/A conversion is done by converting to 4-20 mA.This
is known as analog scaling.

Transducers are used as analog input device.They have zero
& span setting which scales the value as :
0 V=4 mA
10 V=20 mA

Answer / raj

Just add one resistor of 250ohm

how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test.

1 Answers   CPCL,

---

What will be done if we open the secondary of CT on load??

4 Answers   Engro,

---

why when i start my diesel generator it takes 1 minute or less then stop, and i checked the oil sensor is ok and when the generator start i can get 220 voltage but it it is stop after 1 minute or less, how can i solve this problem?

1 Answers  

---

how can we select the appropriate VCB ?

0 Answers   Reliance,

---

If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?

0 Answers   Amara Raja,

---

why transformer donot allow the dc?

17 Answers   ONGC,

---

how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .

0 Answers   Birla,

---

Inverter. converter. Ups.MCB.solar.alternators. motors.

0 Answers   Cisco,

---

how can we say that stator magnetic field rotates with synchronous speed?can we derive?

0 Answers  

---

What is power focter ?

6 Answers  

---

Difference between earthing & grounding.?

0 Answers   Nitco,

---

What are the reason of unbalanced secondary voltage of HT transformer 33kv/6.6kv ? Incomming voltage is balanced.33kv each secondary voltage 6.6 kv 6.4 kv 6.4 kv At no load conditions.

1 Answers  

---