whats the one main difference between UPS & inverter ?
And electrical engineering & electronics engineering ?
Answers were Sorted based on User's Feedback
Answer / sripellirajukumar
hi
this is sripellirajukumar
ups means uninterrupt power supply..ups r
inverter means the device which convers DC voltage into
AC...
Is This Answer Correct ? | 7 Yes | 10 No |
also type the answer for ups & inverter
current flow through the conductor is called electrical
current flow through the semiconductor is called
electronics
Is This Answer Correct ? | 0 Yes | 3 No |
Answer / sripellirajukumar
Dear all .....
THIS IS sripellirajukumar again...
INVERTER AND UPS WORKS ON THE SAME PRINCIPLE......
UPS IS USED FOR ELECTRONIC PURPOSE
EX:(For computers ........)AND
INVERTER IS USED FOR ELECTRICAL PURPOSE EX:(fans...lighting
equipments)...........
Both are used when the power is not available..these all are
for backup purpose..........
Is This Answer Correct ? | 2 Yes | 6 No |
Answer / sripellirajukumar
hi
this is sripellirajukumar
ups means uninterrupt power supply....
inverter means the device which convers DC voltage into
AC...
Is This Answer Correct ? | 6 Yes | 11 No |
Dear sripellirajukumar,
I think UPS is uninterrupted power supply where the out put
voltage is present all the time, while in inverter the out
put voltage will be available at the time of mains failure
only.
Is This Answer Correct ? | 1 Yes | 6 No |
Answer / sripellirajukumar
sripellirajukumar..
hi..
i have already told correct answer above....
But why all these buys r telling all wronge answers ..why?..
inveter is used only for DC to AC conversion ...but not as
explained (Kunal above)...
thanks....
Is This Answer Correct ? | 1 Yes | 8 No |
why 1.7Uo for HV cable Hi pot test?IE standard why?
how can you calculate fault level ?
Question about ct secondaries connections?
What are the disadvantges of leading power factor
What is the fundamental cause of transients in power system?
can any one tell me the formula to select the thickness of wire selection according to ampere rating
What is the average hieght of a electrical tower? what are the factors that are taken into consideration for deciding its hieght other than voltage level?
how to identify conection leads of an unknown electric motor
IN 3 PHASE INDUCTION MOTORS SOMETIMES COPPER BARS ARE PLACED DEEP IN ROTOR WHY..?
i have three phase 25kva transformer but there is two phase line how can i connect to the two phase line?
what efficiency at 70% loaded transformer
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?