I am having a Phoenix digital to modbus converter. The o/p
of the same is connected to flow computer FB407. But the
digital signals are updated only after one minute in the
flow computer. what may be the cause of delay in
communication? Flow computer is having a scanning period of
less than 1 sec.
No Answer is Posted For this Question
Be the First to Post Answer
Explain what is meant by the term “FLASH POINT” of liquid?
What are different types of control valves?
how to trim the pressure transmitter ?
how to calibrate steam control valve in steam turbine
Operational amplifiers
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
I have installed a RTD whose length is 2250mm(RTD stem length), but it's upper 200 -250mm is out of the reactor, and this upper 200mm stem is surrounded by atmospheric temp. And the lower portion i.e. 2000mm is in contact with the measuring fluid, then does the final measuring temp. Gonna change as the upper 200mm RTD stem is out of reactor?
1 Answers Process Control Technologies,
how to calculate density?
What are different types of valves?
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
0 Answers Reddy Labs, ScienceWay,
in which mode of the zener diode act when load voltage is approximately constant
what is maximum vaccume?