When neutral is grounded in electrical circuit?
Answers were Sorted based on User's Feedback
Answer / abhiramsahu2007
FOR STAR CONNECTED CKT ,TO BALANCING CURENT THE NEUTRAL IS
GROUNDED
Is This Answer Correct ? | 28 Yes | 2 No |
whenever a live wire touches an enclosure of an equipment a
ground fault occurs, so to provide the personnel protection
the equipment enclosure is connected to grounded neutral
wire through a grounding conductor to make earth and
enclosure electrically common. At the same time the ground
fault current flows from the enclosure back to the source
to trip the protection device
Is This Answer Correct ? | 4 Yes | 0 No |
Answer / saurabh
1) Neutral Shifting is Prevented.
2) System/Personal Safty increses
Is This Answer Correct ? | 4 Yes | 2 No |
Answer / eduardo
There are 3 types of neutral systems: TN TT and IT. In both
TN and TT the neutral should be connect to earth. IT the
neutral should not be connect to earth (or connect via a
high value restistor).
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / gunasekaran
where it is sorce end and distribution level
Is This Answer Correct ? | 0 Yes | 2 No |
Answer / gunasekaran
if it is source end it should be another one is
distribution end.
Is This Answer Correct ? | 0 Yes | 2 No |
when you use input side delta-star txt
than u txt secondary u will connected the neutral and u r
load is safe and search voltage going to grounded.
Is This Answer Correct ? | 2 Yes | 5 No |
Everybody Knows What is ACB, VCB but anybody tell me what is ST?
Define characteristics impedance?
how to determine capacitor bank capacity of one plant..
how do you tell if a avalanche button diode is a p or an
Why NGR is provided in sub station?
what is the solution for meger test failed the MV cable?
1.4 What is meant by CT knee point voltage and how would you determine it
Difference between single phase and three phase?
can we run 3 phase induction motor under 2 phase supply
why high current produce in case of transformer when turns are internally gets shorted.
WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)