Interested to Buy Any Domain ? << Click Here >> for more details...
When neutral is grounded in electrical circuit?
- 9 Answers
- 12758 Views
- Balco, I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
where it is sorce end and distribution level
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
How to decide whether A / B / C / D curve type MCB should be used?
why output is out of phase in case of common emitter?
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
What is the temperature PROFILE OF A FLUID W. R. T. Distance from a sphere to which it is IN CONTACT which is at constant temp.?
full form of flry b
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
Why Neutral Isolation is required?
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
How to calculate the Harmonics losses in terms of cost/unit.
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
how brushed dc motor operating ?
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
What is the effect of pd controller on system performance?
