When neutral is grounded in electrical circuit?
- 9 Answers
- 9880 Views
- Balco, I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
if it is source end it should be another one is
distribution end.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
1hp= how much rpm
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?
how to find the Motor,s insulation Power?
what is the total power generation in india?
how will we calculate the copper wire load..
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
Phase control and integral control are used for?
how we do Vector group ,magnetic balance and tap changer test in Transformer?
what is PID control in VFD drives?
What does a Bode plot tell you?
WHAT IS IM (INDEX OF MOUNTING )IN MOTORS
What are the main advantages of bode plot?
how choose conductor&depending upon load
What is current divider rule (cdr)?
