Answer / shaikh arif

drive speed is the speed equal to that of driving
mechanism.like the gear which is mounted on driving shaft
which is conected to motor.and driven speed is that which
is rotated by the driving mechanism.like the gear on other
shaft which is reciving power to the driving gear.

Answer / kumar

Ex: Motor drive and Pumps is Driven
Here is Motor is the basic source for rotation whethere it
is motor or turbine or by ur hand also.
all these are used to ratate something.

Ex. if u want power, then u have to rotate generator. For
this generator rotation, u have to rotate gas turbine or
steam turbine or hydraulic turbine.

here turbine is the driver and generator is the driven

Answer / bhavik kumar

In Simple
The input power called drive speed and
The output power called driven speed...
thank u....

Answer / raja

For Example local gensets the prime motor or engine
delivers the drive speed
the gensets rotating at the driven speed

Answer / nizam

in car,engine speed is the drive speed,wheel speed is the driven speed.i.e.engine is the drive and the wheel is the driven.
drive speed will be higher than driven speed depends on the application.

Answer / sujay.........

In MOTOR & GEARBOX.
The motor is coupled to the input shaft of the gearbox by
suitable coupling.
In this arrangement motor output shaft rpm is transmitted
to the gearbox input shaft.
So in this, drive speed is the speed of the motor & driven
speed is the speed of input shaft of gearbox.

Input shaft speed of the gearbox is not equal to output
shaft. it may be greater or lower depending on the gear
ratios.

Answer / ankush miglani 9718151073

look the drive speed is wat produced by the source while
the driven speed is wat consumed by the sink.

Answer / hameedwahab

Drive Speed - Speed of Primover.
Driven Speed - Speed of connected equipment.

Answer / neeraj

in bycle the driven is larger dia and in bycycle this reverse jst think bout

Answer / premchand.v

the actual speed of any machine (motor etc), is the drive
speed. when the same is coupled with any other element say a
wheel, the speed of the wheel is the driven speed.

what is the stanton curve?

0 Answers   IGCAR,

Why head of a centrifugal pump is independent of density of fluid?.

0 Answers  

What device installed in the F.O. system when excess oil return to drain tank?

0 Answers  

in project refinery oil (petroleum) , what type of pump is used?

1 Answers  

The capacity of a domestic refrigerator is in the range of ?

0 Answers  

Why do we use solid shafts for transfer of power in case of pumps/ turbines & other machines why we use a hollow shaft (pipe) in universal joints of automobiles; although the rated load and twist is approx. the same?

9 Answers  

16 inch = 1 ______________?

5 Answers  

What is the difference between heat capacity and specific heat of a material ?

0 Answers  

sir,i am golng to attend BHEL supervisor trainee personal interview on 11 sept.anyone share me that how could i perform well in interview& what they would expect from me. thank you.

0 Answers   Bhel, Ford,

• Would you be willing to relocate if required?

1 Answers   Petro Star Mount,

what is the required force to bend 2.5 MS sheet in 90 degrees and what is the formula to calculate the same?

0 Answers   Voltas,

why we can shut down dischareged valve of centrifugal pump while running?

2 Answers