what type of earthing is done on hilly rocks.
Answers were Sorted based on User's Feedback
Answer / pappu meena
Jel earthing should be done in rock/hill areas.
Is This Answer Correct ? | 10 Yes | 3 No |
Answer / munish sharma
In Rocky Area the soil resistivity comes out to be very
high.The overall grounging structure is based on following
criteria
1.Area Of the Switchyard
2.Surface Layer Resistivity
3.Soil Structure
4.Safety PArameters
5.Fault Current Distribution
There Are Certain Techniques in case of HIgh Soil
Resistivity as
1.Deep Groung well Earthing
2.If area is limited of the Switchyard,use Remote grid
along with main grid buried in low resistivity material
3. Soil Treatment
4. Use Grounging rods to take effect of deeoer low
resistivity layers
Is This Answer Correct ? | 6 Yes | 2 No |
Answer / leturtle
Totally depends on your application. Is the ground 'solid'
rock or fragmented mixed in with other material?
What kind of rock? Limestone, granite, mudstone, sandstone?
Depending on the type of rock will determine what solution
will best fit.
Is there any top soil on the surface?
Is This Answer Correct ? | 5 Yes | 6 No |
what is purpose of manual bybass in ups
what is differance bw ELCB and MCB. ?
1.protection used in transformer ? 2.Why breather called breather ? 3.Working of conservator tank.? 4.Speaker of parliament ?
sir i had plane to do some project with the base of hopkinson test in AC supply its possible
What will be MF for below rating ? Main CT PT value is 11kva/110 and 20/5 amp Meter display is 1kva/110v and -/5 amp What will be MF ? Multiplycity factor of energy meter
what is bus coupler, where it used.
How can we determine or find out the proper size of any cable if nothing is mentioned on it.Calculation of size in Sq.mm???
6. A DC AMMETER HAS R=0.1 OHM & CURRENT RANGE IS 0-100 A IF THE RANGE IS TO BE EXTENDED TO 0-500 A THEN METER REQUIRES SHUNT RESISTANCE OF ..........
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
In an ammeter used for measurement of current, what is the meaning of the representation of range as '0-50-300'?
why the neutral of power transformer is always earthed?
How to find the maximum load(in KW)in a big industry, having motors,lights,lifts etc..?