WHAT SHOULD BE THE MINIMUM IR VALUE FOR LV (380V) CABLES
ACCORDING TO IEC/IEEE.

Answers were Sorted based on User's Feedback



WHAT SHOULD BE THE MINIMUM IR VALUE FOR LV (380V) CABLES ACCORDING TO IEC/IEEE...

Answer / rekha

1mega ohm

Is This Answer Correct ?    4 Yes 3 No

WHAT SHOULD BE THE MINIMUM IR VALUE FOR LV (380V) CABLES ACCORDING TO IEC/IEEE...

Answer / snn murthy

minimum 1.3 megaohm

Is This Answer Correct ?    2 Yes 2 No

WHAT SHOULD BE THE MINIMUM IR VALUE FOR LV (380V) CABLES ACCORDING TO IEC/IEEE...

Answer / ashish patil

minimum 1Mega ohm

Is This Answer Correct ?    5 Yes 7 No

Post New Answer

More Electrical Engineering Interview Questions

what is difrent between earthing and ground

4 Answers  


HOW TO CALCULATE S/C,O/C,E/F OF ACB.

0 Answers  


what should be distance between two electrical earthing pit as per i.e.e

13 Answers   Badve,


What is Toroid?. What is the difference between toroid and Current Transformer

1 Answers   DAE,


A group of machines (wind turbines) connected with 33KV feeder and each machines are having individual VCB. The 33KV feeder connected with 110KV/33KV substation. The 33KV feeder tripped by over current at Substation and fault recorded at Substation as OC-R&Y phase. Same time the group of machines VCB tripped by over voltage, the fault recorded voltage was above 66KV by numerical Under/Over voltage relay. While grid drop time, this much of voltage hike is possible?

1 Answers  






plz tell me in my que,how to connect thw electrical wirening in house?

1 Answers  


which level of transformer oil has got low dielectric strength ?why?

2 Answers  


which one is more costly:single phase induction motor or 3 phase induction motor??give proper reasons..

1 Answers  


what is mean by derating factor?

4 Answers   Essar,


why do we use 3 single phase instead of one 3 phase?? though vee connection is its advantage but what is the hidden reason behind it??

2 Answers  


Zone of protection and tripping scheme of arc protection relay.

0 Answers   KSEB, L&T, Siemens,


what happen if the parallel generator phase angle shift by 1 degree in manual mode

0 Answers   EEEC, MEC,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)