Answer / kishor mahale

opamp has two input and one output. it compare or
differentiate two input and gives respective output of input.

Answer / vinay kr

As it has 2 inputs & 1 output & o/p is wrt 2-i/ps,now a
block with minimum(sufficient) area producing 1-o/p
corresponding to 2 i/ps must be triangle with o/p at its
vertex .It shows above picture with min area as triange

Answer / ang

the opamp has 2 inputs and only one output, so its like a
device which accepts 2 datas and give one data as output.
the best geometrical figure which can describe it is a
triangle : 2 i/p s at the lower side and o/p node at the
opposite vertex

Answer / josh

because it has 2 i/p terminals having high i/p impedence
which can b showm in for of two terminals ......compared to
its o/p impedence which in ideal case is considered zero
appox.......... so shape covention is triangular

Answer / brajesh kumar sah

Because its having two input and one output , the output are the difference of the two input that why its make triangular shape.

Answer / pra

The shape of op-amp symbol is triangular because it shows the arrow,and this arrow is indicating the power transfer from input of an op-amp to the output.

Answer / anushareddy

Because to transfer the power from input terminal to output

Answer / bablu

it gives the direction of signal flow

Answer / veena

the direction of flow of current is shown in a particular
direction. and it is obviously a diferential amplifier
having two inputs and a output

Answer / harshita

because the triangular shape is like an arrow which shows
direction of current flow from input to output

List the materials used for manufacturing pcb

0 Answers  

Explain 3 dB cutoff frequency? Why is it 3 dB, not 1 dB?

2 Answers  

L&T APFC Relay model etacon L8 fault: Initial power factor is 0.6 when capacitor is on, the value of power is getting down, please let me know the reason and rectification details.

1 Answers  

what your doing work capacity?

1 Answers   Denso,

What is the difference between a multiplexer and encoder? Also what is the between demultiplexer and decoder?

0 Answers  

SIR,i am applying for the jr.engineer(signal)post.kindly if you send some previos sample question -answer i will be higly obliged

0 Answers  

plz send me some apts question paper for aricent. thanks in advance

0 Answers  

write the difference between network and circuit

3 Answers  

With the help of diagram explain a cmos inverter.

0 Answers  

Can u please post some questions of MTNL junior telecom officer exam?

0 Answers   Lanco,

What are the main components of AMF panel. Is it required to use ATS in LT panel if DG is used as stand by supply? Please send any single line diagram showing AMF & LT panel etc., if possible please send to sreenu_207 @ yahoo.co.in

0 Answers   HAL,

please send me the previous question papers of ntpc writen test for ece

0 Answers   NTPC,