what is the function of a commutator in a dc generator?
- 14 Answers
- 71894 Views
- College School Exams Tests, NTPC, TCS, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / ravi ranjan gupta
it rectifies the output alternating current so as to produce
unidirectional alternating current i.e pulsating DC.it
reverse the negative polarity current to a positive one so
as the output is a pulsating DC
| Is This Answer Correct ? | 146 Yes | 10 No |
Answer / jsenthamizh
Generally all types of generators induced emf in sinusoidal
wave form (A.C). In particularly D.C generator commutator
function is convert A.C emf into D.C.
| Is This Answer Correct ? | 75 Yes | 14 No |
its function is like a rectifier(ac to dc converter)
| Is This Answer Correct ? | 53 Yes | 9 No |
Answer / gururaj
COMMUTATOR IS WORKING AS A RECTIFIER.IN DC MOTOR IT'S USED
TO CONVERT THE AC TO DC.
| Is This Answer Correct ? | 37 Yes | 9 No |
the function of commutator is to lead current from external stationary leads to the rotating coils of the armature winding in case of motor and to draw current from armature winding to external circuit in case of generator
basically it act as a rectifier as it converts sinusodial(a.c.) signal into d.c signal
| Is This Answer Correct ? | 24 Yes | 1 No |
Answer / m.srinivas manoj
in generator only alternating current is produced so to
making it unidirectional we use commutators it acts like a
rectifier to convert ac to pulsating dc
| Is This Answer Correct ? | 23 Yes | 5 No |
Answer / venkatesan.j
It converts alternating current to unidirectional current
and also provied point for collection of current.
| Is This Answer Correct ? | 14 Yes | 5 No |
Answer / francis madukwem
A commutator is device which changes an Alternating current to a Direct current.
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / subhajit gorain
Its function is to collection of current from armeture conductors,sent it to the carbon brush and then it convert the alternating current to direct curreny.so it is called a macanical rectifire.
| Is This Answer Correct ? | 6 Yes | 4 No |
Answer / chiku mahhi
1.Commutator is a mechanical rectifier used to convert ac to dc.
2. Used to reverse the direction of current between rotor
| Is This Answer Correct ? | 0 Yes | 0 No |
What is the exact load current needed for a place which has 100nos of bulb of each 100w?
How to calculate the size of window A.C. for 200 Sq. ft room?
why generaotr rating is in kva and dc motor in kw?
What is meant by control system?
What is required of exietation to the alternater.
Why in Hv transmission line as we see there are generally 6 or more than 4 conductor wires are used instead of 4 i.e. 3 for phase and 1 for neutral wire?????
what is positive , negative & zero equivalent system resistance
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
WHY THE +VE POLARITY OF 48V DC POWER SUPPLY IS USUALLY GROUNDED?
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
what is neutral grounding resistor?
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
