Answer / prasanna

yes.we can run but performance will reduce

Answer / chow

YES

Answer / xv2ps

I also thought yes as above described.
However, we have some electric problems in our factory for
2-3 days with one phase screwing off.
I have signed to rewire over 15 motors.

Answer / imtiaz

yes but low efficiency and reduced torque.

Answer / vinay

YES........
USING CAPACITOR

Answer / deepak (d.p.)

it is really true that wid only 2 phase connected the motor
rotates but with reduced torque andlow efficiency.

Answer / sad

yes it can run by giving mechanical force to rotate the
shaft while starting....

Answer / murugadoss

Take the second phase supply and connect to the capacitor input (15mfd/hp) (make sure the existing phase only to connect across the NV coil). then connect the output of the capacitor to the third phase. start and check the motor is running in the right direction if not change the second phase connection ( capacitor input) to the first phase.
Select the capacitor rating correctly otherwise the motor winding takes overheat and finally it will burn.

Answer / ashok kumar

with 2 phase motor does take place of rotation but motor
should not be loaded .it will start or rotate with humming
sound.after get start the motor, we can load it, but only
with in a limit(which is much smaller then that is in normal
condition) if we loaded the motor with in limit (with in the
range of full load current)it will be continuous in rotation
but its torque will be reduced as well as speed and also
effected its efficiency.

Answer / niranajn

yes but with reduced loading

what type of earthing is done on hilly rocks.

4 Answers  

Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?

0 Answers  

define the non synchoronism of synchoronous machine in general g or m??

0 Answers  

why the earth conductor in top of the tranmission line ?

2 Answers  

What is the difference between Ac curent & DC current

2 Answers   Juniper Networks,

WHAT IS THE USE OF STARTER AND CHOKE IN TUBE LIGHT?

1 Answers   Siemens,

Differnce between negative Pahse SequenceFunction and unbalance Function?

0 Answers   Atsco, LMW Lakshmi Machine Works Limited,

what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero

0 Answers   Jindal,

HOW MANY EARTHINGS REQUIRED FOR GENERATER

10 Answers   Juniper Networks,

As per IS why should the control be taken only from R phase, why not from B or Y phase??!!

2 Answers  

What if the difference beween internal and exrteranal LBB?

0 Answers  

difference between local breaker backup relay or backup protection relay ?

1 Answers