what are the difference between protection class CT and Class PS CT

what are the difference between protection class CT and
Class PS CT

Question Posted / vijaykunaseelan

13 Answers
29928 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what are the difference between protection class CT and Class PS CT..

Answer / vikas

The main difference between Protection Class CT and Class
PS CT is the accuracy level. Accuracy level of a Protection
class CT is higher then that of PS class.

Both Protection class as well as PS class can be used in
both metering as well as in Protection Purpose, depends
upon the criticality of the protection. But generally
Protection class CT is used for Protection purpose whereas
PS class CT is used for Metering purpose (in India).

In foreign projects, only Protection class CT's are used,
no PS class CT is there.

Is This Answer Correct ?

1 Yes

2 No

what are the difference between protection class CT and Class PS CT..

Answer / sanwan

protection class ct have less acuuracy than ps ct

Is This Answer Correct ?

2 Yes

5 No

what are the difference between protection class CT and Class PS CT..

Answer / aruna devi

Protection class CT give more accuracy than PS class CT.ps
class can use only unit protection but protection class
cant be used in unit protection.

Is This Answer Correct ?

9 Yes

56 No

Post New Answer

More Electrical Engineering Interview Questions

4-Why we measure the insulation resistance of main core and frame in spite of that must be connected with ground before energize the transformer?

3 Answers

What is the meaning of CT 40/5, 100/5 or in HT lines 100/1 ????????

3 Answers Amex,

In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans

0 Answers

what happen if rotor earth fault in AVR system?

1 Answers

Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..

0 Answers IOCL,

In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem

0 Answers

What is circuit breaker failure protection?

2 Answers

HOW WE WILL CONNECT THE PHASE CTS AND NEUTRAL CTS TO REF RELY

3 Answers

During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?

0 Answers

why the neutral of power transformer is always earthed?

1 Answers

The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is

0 Answers Caterpillar,

What are the essential parts of a transformer?

2 Answers NIT,

For more Electrical Engineering Interview Questions Click Here