Sir i am preparing for PSU exam for ONGC but i am not able
to get the appropriate syllabus and previous year question
papers. Kindly send me the same, that will be a great help
from ur side. OR if anyone can plz send me the papers and
syllabus please.
Answers were Sorted based on User's Feedback
Answer / avin
first tell ur branch,then work on the
genral knowledge + subject ur havin
Is This Answer Correct ? | 37 Yes | 15 No |
Answer / smruti
4 psu ,u ve to strong in apti nd general knowledge 4
nontech sect.they follow the pattern of GATE nd IES exam.abt
the tech section,it varies wrt to the sector nd also
company. go through the current affr also,best of luck.
Is This Answer Correct ? | 22 Yes | 2 No |
Answer / swati
for pSU u need to hv command over d subjcts u hv in btech +
d current affairs...
Is This Answer Correct ? | 16 Yes | 3 No |
Answer / khalik
tell ur branch,ask ur seniors & teachers,at this time u r at
right way............best of luck...
Is This Answer Correct ? | 13 Yes | 6 No |
Answer / nidhi
i think , u r the student of b.tech from che engi .u should
take help ur tearchers and ur friends.
Is This Answer Correct ? | 9 Yes | 13 No |
Answer / prabir basak
i am an instrumentation engineer so go though the papers of
your department and verbal,quanti english
Is This Answer Correct ? | 45 Yes | 79 No |
Answer / ankit gupta
if u are nervous then dnt even think abt it....
Hv a nice day..
Is This Answer Correct ? | 17 Yes | 58 No |
Answer / viren_74787
u have to paid for me ,i have all paper set up.
Is This Answer Correct ? | 14 Yes | 57 No |
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
what is the difference between sinking and sourcing inputs and also what are there applications?
what can of fault ofently come in vibration mesurement?
what is the difference between profibus and controlnet networking.
what is the difference between plc and pc?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
what is difference between DO and DI
what are procedure of sox-nox calibration
why we are using -24 vdc in plc?
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
how to calibrate 0- 150 psi presure gauge by dead weght tester