Answer / rahul kumar saraswat

actually there are two parts one is stator and other is rotor.the inner part is called rotor while the outer part is caled stator.in ceiling fan stator is rotating while on the other hand rotor is rotating.this is the main difference.

Answer / pravin pavadshetti

you can mount table fan on the celling if you want but you
cannot a celling fan on the table

Answer / rohtash kathwalia

In ceiling fan stator is rotating part and in table fan
rotor is the rotating part. Ceiling Fan Rotate in anti clock-wise direction by bearing and table Fan Rotate in clock-wise direction by bush.









Table Fan-*Rotation is in Anti clock-wise direction
*Used Bushing

Answer / aby

in ceiling fan field rotates whereas in table fan armature rotates

Answer / parameshwari

usually in motor there will be two parts
(1)stator-armature part
(2)rotor-magnetic part

ceiling fan:
armature is made as rotating part (if we want to make the armature as rotating part than we need to have more space which is not possible in case of ceiling fan)

table fan:
magnetic part is made rotating so there is no need of using commutater,and armature is made stationary

Answer / gunashekara a.c

The table fan speed cannot be controlled for very low speed.It is a portable.(only two of four pole)
The ceiling fan can be run very low speed (the motor can be designed for more number of pole. .

Answer / aditya

the main difference is in the design of winding in the motor

Answer / chinmay paradeshi

ceiling fan mostly when run on inverters make noise and
table fan don't noise.

Answer / om prakash

The ceiling fan rotates to lo speed.
But the table fan rotate high speed compare to ceiling fan.

Answer / mousumi

in ceiling fan there is single phase im is used.so here
stator rotates.in table fan universal motor is used which
is lik dc motor.here the rotor part rotates.

Main CT ration is 400/5, meter CT ratio is open type: -/5A. What is the Multiplying factor of the meter, considering same PT ratio.

1 Answers  

Explain mechanical rotational system?

0 Answers  

why dc motor runs slowly when dc supply is given?

2 Answers   L&T,

Graphs of measuring power and speed on dc motor

0 Answers  

Which rccb 30ma,100ma,300ma sensitivity should be used in domestic line and what is difference, advantage and disadvantage of all three

2 Answers  

what are the standard values for resistances(Megger testing) between L&N, L&E and N&E (L=Live,N=Neutral, E=Earth)?

1 Answers  

what is the method of electric earth for the protection of low voltage electric equipment

1 Answers   MacLellan, Shiva Corporation, Siemens,

what is joule?

2 Answers  

Whats the difference btwn a latch, port,data bus buffer? Do they all not hold data in d flip flops??

0 Answers  

How to calculate the heat load for a electrical room

0 Answers  

Residual voltage & residual current used in which protection?

5 Answers   Qatar Gas, Reliance, Transformers and Electricals,

why is only third harmonics is dangerous for electrical equipments?

3 Answers