Answer / pravesh

depend on power factor if given . accurate values can be
given out , and where we want to get the current in sec
side or primary side

Answer / satyendra

Depends on the load...
I=V/R,

Answer / subu

amount of no load current is always 0 what ever the rating
of the trasformer, ratio, etc. no load means there is no
close path. then how can we get the current

where solid grounding and where grounding through ngr done and why?

0 Answers   NTPC,

---

In India which type of PLCC IS used?

2 Answers   Cipla, Ford, Jayashree,

---

what will be the neutral to earth voltage while checking by the Digital multimete? and why?

1 Answers  

---

IS THERE ANY ELECTRONIC CIRCUIT TO REDUCE THE NEUTRAL TO EARTH VOLTAGE BELOW 3V ?

1 Answers  

---

WHAT IS MEANT BY SYNCHRONISING IN GENSETS

5 Answers  

---

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

0 Answers  

---

How much weight an electrical engine can pull??

0 Answers   Maruti Suzuki,

---

WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.

0 Answers  

---

What is difference b/w fuse and breaker?

3 Answers   Jindal,

---

what is TRCC

2 Answers  

---

what is the transiant condition in alternator? and how it can be prevanted?

0 Answers  

---

why SCR use in power plant

1 Answers   Edison,

---