can we use HPSV LAMP in HPMV LAMP fixture ?and viseversa.

Answers were Sorted based on User's Feedback



can we use HPSV LAMP in HPMV LAMP fixture ?and viseversa...

Answer / dolnarayan patel

Yes , we can.

Is This Answer Correct ?    18 Yes 5 No

can we use HPSV LAMP in HPMV LAMP fixture ?and viseversa...

Answer / santosh

NO, we can't

Is This Answer Correct ?    8 Yes 5 No

can we use HPSV LAMP in HPMV LAMP fixture ?and viseversa...

Answer / aaaaaaaaaa

no

Is This Answer Correct ?    1 Yes 0 No

can we use HPSV LAMP in HPMV LAMP fixture ?and viseversa...

Answer / anil choudhary

for hpsv lamp we require a igniter.but for hpmv we dont require igniter

Is This Answer Correct ?    1 Yes 0 No

can we use HPSV LAMP in HPMV LAMP fixture ?and viseversa...

Answer / raihanullah

NO, we can't use

Is This Answer Correct ?    1 Yes 1 No

Post New Answer

More Electrical Engineering Interview Questions

PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com

0 Answers   NHPC,


A 6-pole, 50 Hz, 3-phase synchronous motor and on 8-pole, 50 Hz, 3-phase slip-ring induction motor are mechanically coupled and operate on the same 3-phase, 50 Hz supply. If they are left open-circuited, then the frequency of the voltage produced across any two slip rings would be

2 Answers   L&T,


VCB in closed position during opertion if vaccume break then what will happend? it has any protection ?

1 Answers  


what i the full form of ABS 111 in transformer.

1 Answers   Birla, Ford,


If the capacitor bank is installed in switchyard say 132/22kv then on LT side say 22kv/0.433kv is it necessary to install capacitor bank for maintaining power factor. if pf is maintained on HT side then will that be maintained on LT side as well.if not then how&why??????/ please explain...........

3 Answers   MacLellan,






what is the principle of tubelight ??? what is the function of starter and choke ???

1 Answers  


what happen to a dc series motor if it given as ac supply accidentaly

2 Answers   ONGC,


in single phase circuit if i connect a heater between phase and neutral, then what will be the current path? phase to neutral or neutral to phase.

4 Answers  


What do you mean by nominal ratio of instrument transformer?

1 Answers  


What is STEP VOLTAGE ?

7 Answers  


WHAT IS LINE TRAP,HOW IS IT FUNCTION?

1 Answers   L&T,


I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)