Answer / vinothbabu.k

max demand was considering the total losses in equipment
plus the motor required power

. Why the transmission lines are in 11kV, 22kV, 33kv, and why not 10kV, 20kV, 30kV?

3 Answers  

---

Why there are semi conductor layers on conductor and XLPE insulation of HT cables

1 Answers  

---

Sir 33kva 2 transformer load 900 amp calc 1800 amp mana jayega

0 Answers   Classic Infotech,

---

Why short circuit calculation is not required in LT cable sizing and requiredin HT cable sizing only

2 Answers   Chemtex,

---

in electric lamp what is ballast. y its needed to start & stop lamp. what is ballast ckt.

0 Answers  

---

---

what is diffrent between plc and clc??

1 Answers  

---

Classical power system stability was mainly focussed on rotor angle stability but modern power system stability has more focus on voltage stability.Why?

4 Answers  

---

What are the reasons for AVR failure in LT DGsets ?

2 Answers  

---

in transmission line, if the load is suddenly increased at the receiving end of the system the phase shift will (a)decrease (b)becomems zero (c)increase (d)not be affected

4 Answers   Getco,

---

what happen if i connect DYn11 and DYn1 vector group transformer in parrallel?other things are same like votage ration,x/r ratiob etc...

4 Answers  

---

how can we know the size of cable cross-section from current rating ?

3 Answers  

---

Why 36 KV LA is used in 33 KV Line and 9 KV LA is Used in 11 KV Line

1 Answers   APTransco, Bhel, Wipro,

---