I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers  

---

diffrence between alternating and pulsating field?

1 Answers  

---

two or more transformer are working in parallal,one is out of order,what are you doing?

7 Answers   wbsedcl,

---

what do you mean by linear and bilateral network?

2 Answers  

---

IN 3 phase induction motor where we give i/p supply & how its working ?

2 Answers  

---

Single line diagram for dbb (double bus bar)system.

0 Answers   KSEB, L&T, Siemens,

---

when we increased the current what do ?

0 Answers  

---

What happens when ac supply is given as excitation voltage instead of dc supply

1 Answers  

---

WHAT KIND OF LIGHTENING PROTECTION SCHEMS CAN BE ADOPTED FOR THE FLAT ROOF OF BIG DIMENSION.

0 Answers  

---

how does a submersible pump work..?

0 Answers  

---

a distribution transformer(3 phase)supplying 440volt per phase.now suppose one of phase voltage(230volt) becomes zero.what will be the cause ?

3 Answers  

---

which bridge is used to measure frequency?

2 Answers  

---