what r the types of transmission line?
Answers were Sorted based on User's Feedback
Answer / t.mohan
1)OVER HEAD TRANSMISSION 2)UNDER GROUND TRANSMISSION.
| Is This Answer Correct ? | 22 Yes | 32 No |
Answer / aruna devi
there are two types of transmission line.
1.overhead transmission line.
2.Underground transmission line
i.Back to back
ii.bipole
| Is This Answer Correct ? | 21 Yes | 40 No |
Answer / infodoss
there are two type of transmission line are availlable
1.Over head transmission line.
i)i. AC transmission ii.HVDC transmission
ii)i. LV transmission ii.HV transmission
2.under ground transmission line.
| Is This Answer Correct ? | 22 Yes | 45 No |
Two types 1)Primary Transmission and 2)Secondary
Transmission
| Is This Answer Correct ? | 24 Yes | 54 No |
Answer / gins
Low Tension, High Tension and Extra High Tension
| Is This Answer Correct ? | 16 Yes | 56 No |
SUPPOSE A CIRCUIT BREAKER HAS TRIPPED THE THE LINE WHEN A FAULT OCCUR ON IT.NOW WHEN THE FAULT HAS BEEN CLEARED, HOW THE CIRCUIT BREAKER WILL CLOSE AUTOMATICALLY NOT MANUALLY.
6 Answers Bureau of Energy Efficiency, DVC,
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformer
Why only three phase power generation are load are used
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
What's the part of OTCC in transformer?
What is the difference between security constraint unit commitment and security constraint optimal power flow?
0 Answers College School Exams Tests,
What are the advantages and disadvantages of negative feed back?
how to convert the KVAR to microfarad??????????????????
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
what is maximum or Threshold value of current 7 voltage that a common man can withstand
in alternator how we can give power to rotor ? its power is AC or DC ?
when i am going to take trail on a 3ph sq.i/m motor 5.5kw, i observed that RPM of the motor is very low as compared to the rated RPM and also it rotates in clockwise in first ON command,and anticlock wise in second ON command. finally i observed that on phase is no available . but iam not clear about, why the motor is rotates in both directions without any phase interchanging.pls answer to my question.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)