Why only three phase power generation are load are used

Question Posted / n k singh

2 Answers
5402 Views
BARC, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Why only three phase power generation are load are used..

Answer / aniket

three phase supply is used
1.to for higher load
2. more than 3 phase ie 6 phase make alternator complex and
losses in alternator increses,more copper is required.

Is This Answer Correct ?

10 Yes

3 No

Why only three phase power generation are load are used..

Answer / piyush chaturvedi

Three phase balance supply system is the best suited system considering 3 phase loads as well as 3rd Harmonics in generator windings. A star connected load at generation end makes power free from 3rd harmonic whereas 3 phase balance supply makes system more reliable.

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

What is dc current source? Differentiate between ideal and non ideal current sources?

0 Answers

How to set the relay,,??

0 Answers Megatron Solutions, Nestle,

What is the difference between single core 2 wire and single core 3 wire system? Which application we are using this? and for What purpose we are using this?

0 Answers

Everybody Knows What is ACB, VCB but anybody tell me what is ST?

7 Answers

Can we parallel lise the secondary side of the two similiar transformers with same voltage ration, imp, but with different vector groups.. ( for ex. 11 KV / 6.6KV two trfs but different vector groups can we parallelise both of them ,, what happens if we parallelise them

1 Answers

Why we have short circuit the secondary of the transformer

1 Answers

what is control supply rating of a machine

0 Answers

how it can be decided what will be the rating of CT and PT to be used in LT or HT cables?

3 Answers

One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?

1 Answers

how to calculate unit consumption on 3phase 380-415 v0lt kilowatt motor eg ( 55kw,380v,3phase 50-60hz)

1 Answers

why transformer fuse wire is very thin as compared to home fuse wire while voltage lavel is low

1 Answers

write a program that prints prime numbers from 1-20 in digonal form

0 Answers

For more Electrical Engineering Interview Questions Click Here